STIHL HT 100 Instruction Manual download pdf (Page 18)

HT 100, HT 101, HT 130, HT 131

English

16

A cutting attachment consists of the saw

chain, guide bar and chain sprocket.

The cutting attachment that comes

standard is designed to exactly match

the pole pruner.

– The pitch (t) of the saw chain (1),

chain sprocket and the nose

sprocket of the Rollomatic guide bar

must match.

– The drive link gauge (2) of the saw

chain (1) must match the groove

width of the guide bar (3).

If non-matching components are used,

the cutting attachment may be damaged

beyond repair after a short period of

operation.

Chain scabbard

Your pole pruner comes standard with a

chain scabbard that matches the cutting

attachment.

If you use guide bars of different lenghts

on the pole pruner, the length of the

chain scabbard must be matched to the

guide bar to reduce the risk of injury. It

should cover the full length of the guide

bar.

The length of the matching guide bars is

marked on the side of the chain

scabbard.

Removing the chain sprocket cover

N Unscrew the nut and remove the

cover.

N Turn the screw (1)

counterclockwise until the tensioner

slide (2) butts against the left end of

the housing slot, then back it off 5

full turns.

Cutting Attachment

001BA248 KN

1

2

3

a

001BA244 KN

Mounting the Bar and Chain

390BA042 KN

1

2

390BA043 KN

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 103 104

Comments to this Manuals

No comments