STIHL HT 56 C-E Instruction Manual download pdf (Page 26)

HT 56 C

English

24

Filler cap is locked.

If the oil level in the tank does not go

down, the reason may be a fault in the oil

supply system: Check chain lubrication,

clean the oilways, contact your dealer

for assistance if necessary STIHL

recommends that you have servicing

and repair work carried out exclusively

by an authorized STIHL servicing

dealer.

If the filler cap cannot be locked in the oil

tank opening

Bottom of cap is twisted in relation to

top.

N Remove the cap from the oil tank

and check it from above.

N Place the cap on the opening and

rotate it counterclockwise until it

engages the filler neck.

N Continue rotating the cap

counterclockwise (about a quarter

turn) – this causes the bottom of the

cap to be turned to the correct

position.

N Turn the cap clockwise and lock it in

position – see section on "Closing".

The saw chain must always throw off a

small amount of oil.

NOTICE

Never operate your saw without chain

lubrication. If the chain runs dry, the

whole cutting attachment will be

irretrievably damaged within a very short

time. Always check chain lubrication and

the oil level in the tank before starting

work.

Every new chain has to be broken in for

about 2 to 3 minutes.

After breaking in the chain, check chain

tension and adjust if necessary – see

"Checking Chain Tension".

002BA583 KN

Left: Bottom of cap is twisted –

inner mark (1) in line with

outer mark.

Right: Bottom of cap in correct posi-

tion – inner mark is under the

grip. It is not in line with the

outer mark.

002BA584 KN

1

002BA576 KN

Checking Chain Lubrication

390BA048 KN

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 103 104

Comments to this Manuals

No comments