STIHL HT 56 C-E Instruction Manual download pdf (Page 35)

HT 56 C

English

33

For periods of 3 months or longer

N Drain and clean the fuel tank in a

well ventilated area.

N Dispose of fuel properly in

accordance with local

environmental requirements.

N Run the engine until the carburetor

is dry – this helps prevent the

carburetor diaphragms sticking

together.

N Remove chain and bar, clean and

spray with corrosion inhibiting oil –

always fit the chain scabbard over

the mounted cutting attachment.

N If the unit is stored with the drive

tube disassembled: Fit the

protective cap on the drive tube to

avoid dirt getting into the coupling.

N Thoroughly clean the machine – pay

special attention to the cylinder fins

and air filter.

N If you use a biological chain and bar

lubricant, e.g. STIHL BioPlus,

completely fill the chain oil tank.

N Store the machine in a dry and

secure location Keep out of the

reach of children and other

unauthorized persons.

N Remove the chain sprocket cover,

chain and guide bar.

Replace the chain sprocket

– after using two saw chains or

sooner

– if the wear marks (a) are deeper

than 0.02 in (0.5 mm) since this

would reduce the life of the chain.

Use a gauge (special accessory) to

check the depth of the wear marks.

It is best to use two saw chains in

rotation with one sprocket.

STIHL recommends the use of original

STIHL chain sprockets.

The chain sprocket is driven via a friction

clutch. Have the chain sprocket replaced

by a servicing dealer.

STIHL recommends that you have

servicing and repair work carried out

exclusively by an authorized STIHL

servicing dealer.

Storing the Machine Checking and Replacing the

Chain Sprocket

a

000BA054 KN

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 103 104

Comments to this Manuals

No comments